Model DS1UIA Dual input way 10 MHz Distribution Amplifier / Splitter with individually gain controllable outputs, dual redundant amplifiers. Features. Bandwidth DC to 10, or MHz; Fixed or variable gain up to 60 dB (x 1,); Noise down to nV/√Hz; True DC coupling, switchable to AC. 10 kHz - MHz RF Amplifiers · SSM RF Amplifier for Conducted Immunity Testing · ETS-Lindgren RF Amplifier 10 kHz - MHz, Watts · Amplifier. This is an ultra linear low noise amplifier that provides exceptional 40 dB gain with only dB noise figure. The input damage level is high at +10 dBm. 10 Channel 10 MHz or 5 MHz Distribution Amplifier NDD-R 10 Channel Frequency Reference Distribution Amplifier Features Low Skewing and Low Phase Noise T. Features: Four Independent Amplifier Channels; BNC connectors; Loop-thru output; 6 isolated outputs per channel (50 ohm); 10 MHz frequency.
Four Independent Amplifier Channels; BNC connectors; Loop-thru output; 6 isolated outputs per channel (50 ohm); 10 MHz frequency response; Gain control for each. The L produces Watts of Class A linear power output over the entire frequency range from 10 kHz to 10 MHz. Observatory 10 MHz Reference Distribution Amplifier. Whitham D. Reeve. 1. Introduction. A reference signal is used in an observatory or on a test bench to.
The LMV is a low-power, wide-bandwidth operational amplifier with an extended power supply voltage range of V to 12 V. The device features 10 MHz of. The E&I L produces Watts of Class A linear power output over the entire frequency range from 10 kHz to 10 MHz. It has very low harmonic distortion along. Our superior quality 10 MHz to 20 GHz, Medium Power Broadband Amplifier with 25 dBm, 13 dB Gain and SMA ships worldwide.
The FS/FS Series Distribution Amplifiers are used to distribute a low noise 10 MHz frequency reference. Each system has one input and seven outputs. 10 MHZ Distribution Amplifier 10 Output ports - 5 LVCMOS + 5 Sinewave Isolated 50 Ohm ports Internal ppm TCXO factory trimmed Disable output sync. 3 dB NF, 10 MHz to 6 GHz, Low Noise Broadband Amplifier with dBm, 34 dB Gain, dBm IP3 and SMA from Fairview Microwave ships same day globally.
A distribution amplifier is used to distribute the output of a frequency reference to many different places. Usually the frequency is 5 or 10 MHz but we. The EPC is a high efficiency, differential mode class-E amplifier demonstration board that can operate up to 10 MHz. This board may also be used for. n Gain Bandwidth Product: 10MHz n –40°C to 85°C Operation n Slew Rate: V/µs n Low Input Offset Voltage: mV Max n High Output Current: 25mA Min. Really high-quality Galvanically output 10Mhz Distribution amplifier board for Lab Instrument reference distribution, can be used with any Lab instruments GPSDO.